Rex-Electrolux FI290SA User Manual Page 1

user manualFridge-FreezerFI290/2TAFI290SA

Technical data Dimension of the recess Height 1580 mm Width 560 mm Depth 550 mmRising Time 20 hThe technical information are situated in

On the opposite side:1. Tighten the lower pin.2. Install the lower door.3. Tighten the middle hinge.4. Install the spacer.5. Install the upper door.6.

between the appliance and the kitchenfurniture is correct.Open the door. Put the lower hinge coverin position.44mm4mm3. Attach the appliance to the ni

7. If the appliance must connect laterally tothe kitchen furniture door:a) Loosen the screws of the part (G) andmove the part (G).b) Tighten the screw

12. Remove the brackets and mark a dis-tance of 8 mm from the outer edge of thedoor where the nail must be fitted (K).HaK8 mm13. Place the small squar

product is disposed of correctly, you will helpprevent potential negative consequences forthe environment and human health, whichcould otherwise be ca

212714171-00-08102009www.electrolux.com

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comContentsSafety information 2Operation 4First use 4Daily use 4H

• It is dangerous to alter the specifications ormodify this product in any way. Any dam-age to the cord may cause a short-circuit,fire and/or electric

by a qualified electrician or competent per-son.• This product must be serviced by an au-thorized Service Centre, and only genuinespare parts must be

Important! In the event of accidentaldefrosting, for example due to a powerfailure, if the power has been off for longerthan the value shown in the te

the compressor may run continuously,causing frost or ice on the evaporator. Ifthis happens, set the Temperature Regu-lator toward warmer settings to a

• rinse and dry thoroughly.Important! Do no t pu ll , move o r d amage anypipes and/or cables inside the cabinet.Never use detergents, abrasive powde

Periods of non-operationWhen the appliance is not in use for long pe-riods, take the following precautions:• disconnect the appliance from elec-tricit

Problem Possible cause SolutionThe temperature in theappliance is too high.The temperature regulator is notset correctly.Set a lower temperature. The